Tsurumi LSC1.4S Puddle sucker flood pump is able to pump water down to 1mm, which makes it suitable for pumping large or small areas of nuisance water found on flat surfaces. It incorporates a dual position outlet port, to enable the user to position the outlet hose horizontally or vertically and avoid it kinking. 

For durability, during robust handling, puddle sucker flood pump has a pressed steel outer casing and a cast aluminium pump stand, to offer increased protection of the steel and rubber base plate. A combination of a rubber pump chamber and a urethane vortex impeller enables the design to offer excellent wear resistance in site water applications that contain sand and silt in suspension, thus maintaining performance and reliability. An additional feature is an integral swing check valve to prevent back flow of water from the discharge hose. Quality is further enhanced with a 403 stainless steel shaft that is fitted with an ultra hardwearing double mechanical seal (inboard: silicon carbide-silicon carbide) – which runs in an oil chamber that has an oil lifter to maintain seal lubrication during operation in any position. 

This feature, combined with the water and air cooling route to the top outlet, allows the pump to operate for extended periods with little or no water. Used widely by hire outlets, utilities and flood control companies. Supplied with 10 metres of heavy duty rubber power cable.

The Sensor is an electronic float switch with stainless steel probes. These are encapsulated in impact resistant moulded rubber, hence this switch is suited to portable applications.  However, the compact design and precise level control also makes it suitable for fixed installations and narrow or shallow sumps. The sensor is supplied with probe extensions to enable pumping down to 85mm, or further, depending on the sump size/area being drained.  

- Outlet 50mm

- Voltage 110v

- KW 0.48

- Flow 170 Lpm

- Head 11m

- Free Passage 6mm